PRIMER EPOSSIDICO BICOMPONENTE
Fondi
Epoxy and bi-component primer, with medium-high thickness and high content of active non-toxic pigments (zinc phosphate). It is characterized by a high adhesion and chemical resistance o alkalis and diluted acids.. Particularly suitable for the protection of surfaces of stainless steel, light alloys, galvanized sheets steel and fiberglass. Suitable for touch-ups on the solder joints or for repairing damage caused by epoxy coating. It can be covered with a different range of products such as chlorinated rubber, alkyd, vinyl, polyurethane, synthetic, epoxy. Good resistance to water and corrosion
Specifications
| Typical thickness | 40 μ to 100 μ (dry) |
| Dried product appearance | matt (5-10 gloss) |
| Mixing ratio | catalyze to 20% by weight or to 27% by volume with Catalizzatore Epossidico Universale (Caf) |
| Pot-lite at 20 ° C | 8 hours |
| Flash point | 26°C |
| Resistance to temperature | 140°C |
| Application | roller, spray, airless |
| Dilution | 5-10% approx. with Diluente Universale (Caf) |
| RESA | 6-7 mq/lt ca. con una mano, secondo lo spessore applicato |
| Yield | 6-7 sqm/lt, 1 coat |
| Drying time at 20 ° C | 20-25 minutes to the touch, hardened depth in 48 hours |
| Recoat | minimum 12 hours in normal conditions of temperature and humidity, but no later than 48 hours in order to allow a better grip of the topcoat |
4 L – 0,750 L
Protect from frost
White, grey, oxide red,
some RAL colors
Use nitro thinner
immediately after use
